Virtual Mains

[Bryan]

Is there a way to force a project to use only 1 main if the file had been saved with the virtual main setting at 8? After I set the Virtual Mains to 1, I get an error message that requires me to change it back to 8 to open the file up.

[Alan]

You have to change the outputs to 1&2 in your track assignments first.Another way would be to remove the extra outputs in the driver section.

[Bryan]

I removed the outputs and set the tracks to 1&2, but now that I think about it I didn't check the tracks I hid. I bet that will do it.

Thanks